can we code it with apps like mixly or no ?

Can I turn on the robot and change between strategies without using the remote because in our competitions they don’t allow turning it on and off using remote Admin Reply: Yes, but for fast robots we don't recommend without any delay to start physically. With button of Ardupro 5 second delay can be added.

Abdulrahman Alsubeay

Can I turn it on and of and change tactics without using the remote? Admin Reply: Yes, Tactics selected by main controller Ardupro's Dipswitch.

Abdulrahman Alsubeay

I need a sample arduino project working on this chasis. Any links would be appreciated. I could not find any on the web using this chasis.

Is the EN pin the same as the Disable pin? If yes then why is inverted logic for it? On the image of the motor driver it says that its off when the En is low, but in the description its off when the Disable is high. Which is the correct one?

The robot came in fully assembled with all of its parts already installed.I used this robot in a robotics competition where the other competitors were amused with the robot and they were scared to practice with me and whenever we come to the ring the others left and just watched us. Overall very cool robot, the motor drivers is amazing being able to handle many volts with no issues or lag., The motor is very powerful even being able to match 4 overvolted titan dc motors which my opponent used. The magnets are very powerful but it wpuld be nice if the bottom had more holes for more magnets.10/10 very poweerful robot would reccomend to buy.

This Arduino controller board is very nice with its built in switches and buttons with it's ability to handle many volts but I had issues with the power switch being broken and the Arduino Nano getting fried other than those issues this is a very powerful board to be used for sumobot robots. Would reccomend to buy!!!

what size of silicon wheel fits into this motor? Admin Reply: JS5230, JS4320 wheels are suitable. At JS4320 wheel model we have 4mm and 6mm center hole options. only Suitable with 6mm Holed model.

The best motor i found to have good speed and good torque, it holds 12v without problems

The Rpms are before the 48:1 reduction? I want to know the final speed of the robot. Is it 400 rpm / 48 * 2 * PI * WheelDiameter/2 400/48*2*PI*26/2 = 680 mm/min This is too low for what i would like for the robot. For a 800mm diamenter sumo table, it takes more than 1 minute to go from one side to the other... Is something wrong in my numbers, or i need less reduction motor? -------------- Admin Reply: Always, our RPM values are final outputs of DC gear motors. Standalone motor speeds usually higher than 10K Rpms. So these values are "after" reduction. That you can use at your robot directly with these datas.